Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Cost in Union City?
Garage door repair in Union City typically costs $150 – $600, depending on what failed and which parts are involved. The most common call we get, a broken spring, usually lands between $180 and $340 for a single spring. A full new door installation runs $700 – $2,200, and the written estimate you receive before any work starts sets the final price.
Every job is quoted upfront so you know the number before a technician touches the door. Estimates are free, and emergency response is available when a door won’t close or a spring lets go. Call (855) 765-9962 to get a real number for your door.
Garage Door Cost Breakdown (2026)
Here’s what the main repair and installation jobs run in Union City and the surrounding South Fulton area. These are typical estimated ranges, not fixed prices. Your actual number depends on the door, the parts, and how much access the technician has.
| Job | Typical Estimated Cost |
|---|---|
| Garage Door Repair (general) | $150 – $600 |
| Spring Repair (one spring) | $180 – $340 |
| Cable Repair | $130 – $250 |
| Opener Repair | $120 – $320 |
| Opener Installation | $250 – $550 |
| Panel Replacement | $250 – $500 |
| Track Realignment | $120 – $240 |
| Roller Replacement | $110 – $220 |
| New Door Installation | $700 – $2,200 |
One thing to know about springs: the $180 – $340 range is for one spring. Most doors carry a matched pair, and when one breaks the other is usually close behind, so a pair is commonly replaced together at roughly twice that range. We’ll tell you which situation your door is in before we quote the job.
What pushes a job toward the top of its range? A door that’s been out of alignment for a while, rusted or bent hardware that has to come out first, a heavier door that needs a higher-cycle spring, or an opener problem that turns out to be a wiring issue rather than the unit itself. What keeps a job at the low end? Straightforward swaps: a single broken spring, a worn roller set, an opener that just needs a sensor realigned.
What Affects Garage Door Pricing in Union City
Union City doors deal with a specific mix of conditions. Here’s what actually moves the number up or down.
- Summer heat and humidity. North Georgia summers are long, hot, and humid. That combination is hard on lubricated moving parts. Rollers dry out, hinges stiffen, and springs work against more friction than they should. Doors that haven’t been serviced in a while often arrive at the repair stage with more than one worn part, which can nudge a job up within its range.
- Spring type and door weight. Torsion springs and extension springs price differently. Most modern Union City homes have torsion systems, which live above the door on a shaft. Older doors, and some builds in the neighborhoods off Highway 29 and near Shannon Mall, still run extension springs along the tracks. A heavier insulated door needs a heavier spring, and that part costs more than the standard one.
- Brand and part availability. A LiftMaster or Chamberlain opener has parts your technician can pull the same visit. We handle LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor, so the odds of hearing “we don’t work on that brand” are low. An off-brand or discontinued system can occasionally mean a slightly longer job while the right part is tracked down.
- Whether it’s an emergency. A door stuck open overnight isn’t the same job as a door that’s been squeaking for a month. Emergency response is a core part of what we do, and getting a technician out fast is the priority. The estimate still comes first, so the price is the price.
- Damage beyond the obvious part. A snapped cable can whip and bend a track. A door that came off its tracks can twist a panel. When the technician finds a second problem, they’ll show you and quote it before doing anything, rather than bundling it in silently.
- Door size and style for new installs. A single-car door in a basic steel panel sits at the low end of the $700 – $2,200 install range. A double door with windows, thicker insulation, or a carriage-house look climbs toward the top. Custom sizing or a non-standard opening adds to it.
How to Save on Garage Door Costs
There’s no magic discount, but there are real ways to keep the bill down without cutting corners.
- Call at the first sign of trouble. A door that’s getting louder or slower is telling you something. Catching a worn roller before it chews up a track is a $110 – $220 job instead of a track-and-roller job.
- Fix both springs at once if they’re the same age. Replacing one spring on a matched pair usually means paying for the second visit soon after. Doing both in one trip is cheaper than two separate repairs, even though the pair costs more than a single spring.
- Get the free estimate in writing. We quote before work starts, so you’re comparing a real number, not a guess. That alone prevents the surprise add-on.
- Repair the opener before replacing it. Opener repair runs $120 – $320. A new opener install is $250 – $550. Plenty of “dead” openers just have a bad gear, a failed logic board, or a sensor knocked out of line. A proper diagnosis saves the difference.
- Don’t skip the spring safety call. Springs are the highest-risk part of the whole system. A wound torsion spring holds serious energy, and a DIY attempt with the wrong tools is how people get hurt. Having a trained technician handle it costs less than an emergency-room visit.
- Ask about the whole system while the technician is there. One visit, full check: opener, springs, cables, rollers, tracks, and panels. Finding a worn part on the same trip costs nothing extra in labor.
Free estimates are the starting point. Call (855) 765-9962 and we’ll get a technician out to give you a real number for your door.
FAQs – Garage Door Cost in Union City
How much does garage door repair cost in Union City?
Garage door repair in Union City typically costs $150 – $600, with most common fixes landing in the $120 – $340 range. A single spring replacement runs $180 – $340, cable repair $130 – $250, and opener repair $120 – $320. Call (855) 765-9962 for an exact quote; estimates are free.
Is it cheaper to repair or replace a garage door?
Repair is almost always cheaper unless the door itself is failing. A $150 – $600 repair beats a $700 – $2,200 new install whenever the panels and structure are sound. Replace when panels are cracked or dented beyond repair, the door is badly out of square, or you’re facing multiple repairs stacked on top of each other. A technician can tell you which side of that line you’re on in one visit. Call (855) 765-9962 and we’ll give you the honest number.
How much does it cost to replace a garage door spring in Union City?
Spring replacement in Union City typically costs $180 – $340 for a single spring. If your door has a matched pair and both need replacing, expect roughly twice that. Springs are the most dangerous component on the door; a wound spring under tension can injure someone badly if it’s handled wrong, which is exactly why we recommend a trained technician rather than a DIY attempt. Call (855) 765-9962 for a free estimate.
Can you come out the same day for a garage door problem?
Yes. Emergency garage door service is a core part of what we offer, not an upsell. A stuck door, a broken spring, or a malfunctioning opener gets priority response, and same-day service is often available. Fast dispatch runs from 7am to 7pm. The written estimate still comes first, so the price is set before any work begins. Call (855) 765-9962 and we’ll get you on the schedule.
How much does a new garage door cost installed in Union City?
A new garage door installation in Union City typically costs $700 – $2,200, depending on size, insulation, and style. A single-car steel door sits at the low end; a double door with windows or a carriage-house look climbs toward the top. We install LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor equipment, so the door and opener can be matched in one job. Call (855) 765-9962 for a free estimate.
Why Choose South Fulton Garage Door Repair for Your Union City Door
Union City homeowners call us because one call covers the whole system: opener electronics, torsion and extension springs, panels, tracks, cables, rollers, and new installations. Our technicians have up to 14 years of experience, and they work on the brands you actually own: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. No brand dead ends, no “we don’t work on that” runaround.
If you need South Fulton Garage Door Repair, start with a free estimate. We’ll give you a typical range over the phone and confirm it with a written quote on site. When a spring snaps or a door won’t close, emergency response is available, not a next-week appointment.
Springs and springs alone are the reason many homeowners call us instead of trying it themselves. That’s the right instinct. Call (855) 765-9962 for a free estimate and we’ll take it from there.
Pricing reflects the Union City market as of 2026. South Fulton Garage Door Repair offers free estimates – call (855) 765-9962.
What Our Customers Say
"Replaced the bottom panel after I backed into it. Color match is close enough that you have to know to look for it."
- Heather Anderson"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Brian Hayes"Good repair, reasonable money. The door still has a slight shudder about a foot from the top that he said is the track being slightly out of true on an old frame and would cost real money to fix properly. Fair enough, but I'd hoped it would be perfect."
- Paul Norris